01-10-2019 06:11 AM - last edited on 09-29-2020 03:33 PM by Kelli Glass
We are integrating a third party device (AnyRover from AnyWeb). The AnyRover appears in the inventory and in the topology. However, in the topology the link between the AnyRover and the connecting Switch isn't shown. LLDP is turned on on both devices. What are the prerequisites for DNA-C to recognize a connections between two devices and show it in topology?
Thanks for your help
Solved! Go to Solution.
01-10-2019 10:27 AM
This is a known technical gap of DNA Center mentioned in the release notes.
Known Issues:
- In DNA Center 1.2.5, Cisco to non-Cisco connections will only be displayed in Topology if the non-Cisco device is configured into a CDP compliance mode. Native LLDP-based Topology with Cisco and non-Cisco devices will be available in a subsequent release.
01-10-2019 10:27 AM
This is a known technical gap of DNA Center mentioned in the release notes.
Known Issues:
- In DNA Center 1.2.5, Cisco to non-Cisco connections will only be displayed in Topology if the non-Cisco device is configured into a CDP compliance mode. Native LLDP-based Topology with Cisco and non-Cisco devices will be available in a subsequent release.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide