cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Choose one of the topics below for Cisco DNA Center Resources to help you on your journey with Cisco DNA Center

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC!
We will not comment or assist with your TAC case in these forums.

298
Views
0
Helpful
2
Replies
Highlighted
Beginner

Time frame to install 50 devices in UI for DNAC?

I am awaiting approval on securing an engineer to help with a DNAC install. I am curious on average, how long should that take if you had around 50-80 devices (access points). 

 

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Time frame to install 50 devices in UI for DNAC?

I think you're asking 2 different questions:

 

1) The DNAC appliance install from scratch might take a few minutes to input all the ip and routing information, then a few hours (at least on 1.2. code, not sure about 1.3) to install all the services for the first time)

2) Assuming this isn't a fabric wireless install, the AP deployment should take the same amount of time as it would without DNAC, since they are still getting all their info from WLC.

2 REPLIES 2
Cisco Employee

Re: Time frame to install 50 devices in UI for DNAC?

I think you're asking 2 different questions:

 

1) The DNAC appliance install from scratch might take a few minutes to input all the ip and routing information, then a few hours (at least on 1.2. code, not sure about 1.3) to install all the services for the first time)

2) Assuming this isn't a fabric wireless install, the AP deployment should take the same amount of time as it would without DNAC, since they are still getting all their info from WLC.

Beginner

Re: Time frame to install 50 devices in UI for DNAC?

That is super helpful thank you!

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards