Hello, I've installed the efm module on a Cisco 829 managed through the kinetic gmm, but I can't modify the broker.json configuration file to configure the efm to connect to an upstream EFM virtual machine, because I can't access the IOX local manager on ... view more

Please check the part of "Network Port Requirements" at https://developer.cisco.com/docs/kinetic/#!requirements/protocol-requirements.  And you may use the verification tool at https://community.cisco.com/t5/cisco-kinetic-documents/verifica... view more

Please refer to https://community.cisco.com/t5/cisco-kinetic-documents/monitoring-modbus-rtu-tcp-assets-in-kinetic-efm/ta-p/3687780   For Kinetic EFM, you may get more information from https://developer.cisco.com/docs/kinetic/#!efm-overview

  Prerequisites: A RS485 Modbus RTU sensor (TMP36 and ADAM 4017+ as an example) A Modbus TCP simulator (ModbusPal as an example) EFM 1.5 installed in IR829 IOx at Edge location EFM 1.5 installed in a UCS or VM at Fog site or Data Center PC&nbs... view more

 This is tool used for verifying the connectivity to Kinetic.