I'd looking for guide or documentation to perform COS vlan tagging in etherswitch modules.
The below configuration works on a standard Layer 3 switch.
class-map match-any Mid_Class
match cos 2 3
class-map match-any My_Class
match 12
match 15
match 18
policy-map My_Tag
class class-default
set cos 2
policy-map IN_COS
class My_Class
service-policy My_Tag
policy-map OUT_COS
class Mid_Class
bandwidth percent 40
class class-default
bandwidth percent 60
Is there any equivalent or translation commands for the Etherswitch modules?