cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
409
Views
0
Helpful
0
Replies

Convert L2 packets to L3 IPv4 packets with Cisco IE4000 series switch

RamDamo
Beginner
Beginner

Hello Cisco Community,

I'm using Cisco IE4000-16GT4G-E switch. I have a need to add Layer 3 IPv4 header (with specific source & destination IP address) to Layer 2 Ethernet packets incoming on one of its port with data rate of around 5 Mbps and send it out on another port. 

 

Is it possible to configure the switch IE4000-16GT4G-E device for the above mentioned need?

 

Best regards,

Ramkumar Damodaran

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: