01-25-2021 09:21 AM
I have an older 2960S and When I visit 10.0.0.1 I am not seeing an express screen.
I have reset the switch and I am able to get the following:
Telnet - to the router.
Show interfaces - display the status of the interfaces.
Show diagnostic log - display the diagnostic log.
Monitor the router - HTML access to the command line interface at level 0,1,2,3,4,5,6,7,8,9,10,11,12,13,14,15
Show tech-support - display information commonly needed by tech support.
Extended Ping - Send extended ping commands.
Web Console - Manage the Switch through the web interface.
01-25-2021 09:32 AM - edited 01-25-2021 09:33 AM
if you are in switch, can you post show run output
or try below : ( configure your Pc with 192.168.1.2 mask 255.255.255.0 gateway 192.168.1.254
interface Vlan1 ip address 192.168.1.254 255.255.255.0 no shutdown ! ip http server ip http secure-server !
try from PC http://192.168.1.254
try attached guide if you can reset again.
01-25-2021 03:30 PM
Post the complete output to the following commands:
sh version dir
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide