cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
91
Views
0
Helpful
2
Replies
Highlighted
Beginner

2960s No Express Screen

I have an older 2960S and When I visit 10.0.0.1 I am not seeing an express screen. 

I have reset the switch and I am able to get the following:

Telnet - to the router.
Show interfaces - display the status of the interfaces.
Show diagnostic log - display the diagnostic log.
Monitor the router - HTML access to the command line interface at level 0,1,2,3,4,5,6,7,8,9,10,11,12,13,14,15
Show tech-support - display information commonly needed by tech support.
Extended Ping - Send extended ping commands.
Web Console - Manage the Switch through the web interface.

2 REPLIES 2
Highlighted
VIP Expert

if you are in switch, can you post show run output

 

or try below : ( configure your Pc with 192.168.1.2  mask 255.255.255.0 gateway 192.168.1.254

 

interface Vlan1
ip address 192.168.1.254 255.255.255.0
no shutdown
!
ip http server
ip http secure-server
!

 

try from PC http://192.168.1.254

 

try attached guide if you can reset again.



BB


*** Rate All Helpful Responses ***

Highlighted
Hall of Fame Community Legend

Post the complete output to the following commands: 

sh version
dir
Content for Community-Ad