cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1123
Views
0
Helpful
1
Replies

Cisco ASA 5506-X Site to Site VPN setup

FrancoRov
Level 1
Level 1

I have the task of setting up a Site to Site VPN connection using two Cisco ASA 5506-X .

I set up the site to site VPN using the Wizard in the ASDM GUI, however, I keep getting this: 

                                                                                              [ERROR] "nat    no-proxy-arp route-lookup"

 

when I finish setting up the site to site. Also, I am unable to ping from one site to the other.

 

I'm also getting this error: 

 

[ERROR] no split-tunnel-all-dns

                        command failed

 

 

can anyone guide me through this so i can finally set this up using the ASDM ?

1 Reply 1

balaji.bandi
Hall of Fame
Hall of Fame

Looks like you have configuration for split tunnel, can you post both the side config to review.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help