03-27-2023 05:56 AM
Hi,
I have a Cisco Firepower 1000 Series and this is my first time configuring it, after I configured some basic interface IPs and routing I clicked on start deployment. After that I couldn't access the Firepower from browser.
I erased configuration from cli local management and tried to access again but still couldn't.
Could anyone advice me with the solution?
Solved! Go to Solution.
03-27-2023 07:21 AM
after I configured some basic interface IPs and routing I clicked on start deployment
if you change from default IP to different IP you may lost connection.
Make sure you have console access, check is the new configuraion applied on the device, if so, change your PC IP to same range IP to get GUI access ?
getting started guide :
03-27-2023 07:21 AM
after I configured some basic interface IPs and routing I clicked on start deployment
if you change from default IP to different IP you may lost connection.
Make sure you have console access, check is the new configuraion applied on the device, if so, change your PC IP to same range IP to get GUI access ?
getting started guide :
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide