02-04-2021 06:37 PM
I’m trying to upgrade my Cisco 7962 & 7965 phone firmware that I just got but I’m having some issues doing it. I setup everything right in the TFTP64 server that I got from watching a video, but when I connect my laptop to either phone, thanks to my ethernet injector, on the phones screens, it says the MAC address, IP address,“upgrading”, and the first firmware link of the file (term65.default) for like 30 seconds, but then the boxes appear that would check mark as the upgrading goes along, it then suddenly stops and just starts doing the boot loop process all over again. Does anyone know how to fix this problem and make it have a successful upgrade all the way? Thanks in advance!
02-04-2021 07:30 PM - edited 02-04-2021 07:31 PM
02-04-2021 07:49 PM
1. Without
2. Unknown - Got the phones in boot loop mode
3. 9-3-1 SR1
4. 7962G - No sticker
7965G - 9.3(1) SR1 or above
02-04-2021 09:20 PM
Can you show us the SEPmacaddress.xml.cnf file?
02-05-2021 09:21 AM
I apologize about my lack of knowledge on this; do you know where I can find the SEPmacaddress.xml.cnf file since I’m not using CUCM? Thanks!
02-05-2021 02:46 PM
@Jman1200 wrote:
do you know where I can find the SEPmacaddress.xml.cnf file
Search in this forum for the filename and my last name. I have answered this exact question so many times.
Without any CUCM/CUE, in order for the phones to upgrade the firmware, you will need the following:
Start with that and let us know how you go.
02-07-2021 11:34 AM
Still no luck.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide