Configure Cisco switch SG250x-24p to allow webui access in all ports

[jonaszed]

Hi everyone.

I am new to cisco and I am struggling to find a way to configure my switch to allow for webgui access on all ports of my switch.

I have access to the webui on port 1 via a directly connected PC. I would like to be able to manage it when it is connected to the lan.

Your kind help would be much appreciated.

Thanks in advance,

[Flavio Miranda]

Hello,

 You can manage the switch from one port probably because this port is on vlan1 and the switch have IP address on the vlan 1.

If you change another port to vlan1 and plug your PC, you will probably have success too.

Now, if that is the case and you want to manage the swich from different vlans, you need to enable inter vlan routing

https://www.youtube.com/watch?v=ZdEe7cU3x1Q

this vide might help you

[balaji.bandi]

As Long as the Manangement IP and Access port your device connected is same, you should able to manage any port using GUI access

example : if you using vlan 1 and ip address 192.168.1.X /24 space, and end device or PC in VLAN 1and 192.168.1.X network you should be able to access GUI, until you have ACL to restrict to some IP address only