cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
513
Views
0
Helpful
5
Replies

File flash:crashinfo_20220421-043234 Device Error :No such device

Ibrohim
Level 1
Level 1

my router not working. it reloading without stop and giving that message "%Software-forced reload" "File flash:crashinfo_20220421-043234 Device Error :No such device".

I changed Flash to another one , but problem same.
what i need to do ...

5 Replies 5

balaji.bandi
Hall of Fame
Hall of Fame
: %ESWMRVL_FLTMG-5-WARNING: Warning: ILP HW Init failed
: %ESWMRVL_FLTMG-7-INTERNAL_ERR: Internal error:

is the device boot or stuck at ROMMON or keep rebooting ?

 

Power down the router - remove any modules installed and boot 

 

Post complete boot (not screenshot please)

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

booting periodical 

 

System Bootstrap, Version 12.4(11r)XW3, RELEASE SOFTWARE (fc1)
Copyright (c) 2007 by cisco Systems, Inc.

​‌C1860 series platform with 262144 Kbytes of main memory

​‌Readonly ROMMON initialized

​‌program load complete, entry point: 0x80015000, size: 0xb700

​‌program load complete, entry point: 0x80015000, size: 0xb700

​program load complete, entry point: 0x80020000, size: 0x264531c

​‌Self decompressing the image : ################################################################################################################################################################################################################################################################################################################################################# [OK]

​‌Smart Init is enabled

​‌smart init is sizing iomem

​‌ID MEMORY_REQ TYPE

​‌0X00135430 Onboard PVDM2 SIMM

​‌0X00003960 Onboard Ethernet

​‌0X0011D000 Onboard VPN

​‌0X000F3BB0 public buffer pools

​‌

0X00703000 public particle pools

​‌

TOTAL: 0X00A4C940

​If any of the above Memory Requirements are

​‌"UNKNOWN", you may be using an unsupported

​‌configuration or there is a software problem and

​‌system operation may be compromised.

​‌Rounded IOMEM up to: 10Mb.

​‌adjusted iome size up to minimum size of: 0X00C00000

​‌Using 4 percent iomem. [12Mb/256Mb]

Hope this was working before ? May be worth reset to factory and try again ?   get in to ROMMON / Format the flash - get IOS from TFTP

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

how can i reset it? it doesn't working properly .
has any option reset in rommon mode?

i changed flash but no effect

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: