cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
545
Views
0
Helpful
5
Replies

SF350-24 Managed Switch - Port isolation

v1taNova
Beginner
Beginner

I have  managed switch and I would like to accomplish the following setup:

 

I want to connect one Residential Gateway(Internet) to the switch(port 1) to feed all the other ports on the switch to the Internet. The problem with this is now any device connected to this switch will see the each other . This will cause problems. So what needs to be done is isolate all the ports on the switch so that each port can ONLY see the port that the RG(internet) is connected to and NOT the other ports.figure.png

5 Replies 5

not sure how to send this code. any idea

 

1.JPG

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

you looking interface range to configure :

 

setp2 has syntanc

 

interface range gi0/0/1-4 ( this means 1-4 have same configuration you going to enter). rather entering in each intercace.

 

is that what you looking ?

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

I still get an error (bad parameter value) when I enter this command:

interface range gi0/0/1-4

 

 

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

this is an example only

 

interface range gi0/0/1-4 ( you need to replace g0/0/.1-4 with your interface number)

 

show interface status gives you interface information.

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers