Hi I have router 887W, he has build in access point.to connect this from router is command service-module wlan-ap 0 sessionso i configure access point but there was few mistake so i was do wrire erase and reloadand that was my mistake becouse router ...
Hi every body! I am totally new in cisco. Just stared. I have a router 887w there is a WAN port but for ISDN (not used in my case), the rest ports from 0-3 is on layer2 and I am not able to set ip address to Fast 0-3. To solve the problem i create Vl...
Good day Ladies & Gentlemen, my name is MJPhipps and i recently joined the community and was wondering which course would be a cheap but good introductory course to enroll in as i am looking into Security & Cloud Support area of work ?
Hello, i upgraded today 4 classes from free to starter, and none of these upgraded. Actually we can t even schedule a free meeting. The payment has been done. What can we do?
Good afternoon, I have a question can u tell me if this type of router support this SFP: GBIC GLC-FE-100BX-U S DOM on the other side will be SFP 100BX-D (this SW can take this SFP) Thanks,
Went to a new Internet provider & was told they didn't support Webex so back to the original one. Now unable to use Webex - same modem as previously. Comes up with "Webex General server error" then "Cancel Retry" when I try to schedule a meeting. The...
Hi there,Ususally you can find the typical power consumption of the switch when it's 0% traffic, 10% traffic and 100% traffic. Although the C9500 datasheets does not contain this information. Does anyone have this information for the C9500 series 48 ...
Sorry, I have to write in German:Bei jedem Neustart öffnet Webex sich automatisch, obwohl ich in den Einstellungen den Autustart rausgenommen habe.In msconfig und auch Task Manager ist kein Eintrag dafür vorhanden. Somit kann ich hier den Dienst nich...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: