Hi I have router 887W, he has build in access point.
to connect this from router is command service-module wlan-ap 0 session
so i configure access point but there was few mistake so i was do wrire erase and reload
and that was my mistake becouse router is working but ap do not heve nothing
i have got this command :
ap:
Are you sure you want to reset the system (y/n)?y
System resetting...
IOS Bootloader - Starting system.
FLASH CHIP: Spansion Mirrorbit (0001)
Xmodem file system is available.
Bringing up flash file system:
flashfs[0]: 2 files, 1 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 31481856
flashfs[0]: Bytes used: 3072
flashfs[0]: Bytes available: 31478784
flashfs[0]: flashfs fsck took 10 seconds.
Reading cookie from flash parameter block...done.
Base Ethernet MAC address: 64:00:f1:77:47:04
Ethernet Interface initialize.
Ethernet Interface initialize OK.
TFTP initialize OK.
Boot system image.
The system is unable to boot automatically because there
are no bootable files.
AP801 Boot Loader (AP801-BOOT-M) Version 12.4(23c)JX, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Compiled Thu 08-Jul-10 11:09 by prod_rel_team
so flash is empty - how to load there and where i can find out files for access point
ps. the router work ok wired...
