I have a General Dynamics Sectera Viper phone I am trying to register to my call manager 11.5. I read to build it as a 7960 SCCP device. Is this correct? It doesn't register.
Thanks!
Hi Team,
Need steps to source ydk08_5 for local run.
Currently i have source the release branch with below steps which shows I am in ydk0.5.5a0 branch.
How to move this to development branch(ydk08_5) for local testing.
source /auto/cafy/release/l...
Hello!I see in routing table routes without mask.how can I get the mask of the received network 192.168.130.0?D EX 192.168.111.0/24 [170/3498496] via 10.250.0.8, 3w2d, Tunnel1 192.168.120.0/30 is subnetted, 1 subnetsD EX 192.168.120.0 [170/...
We are users of a Cisco AnyConnect VPN and we are having issues setting up a split tunnel. The Cisco Firewall is in our on-premise network and we use the AnyConnect VPN to give access to our employees from their remote location to our local network. ...
Guys i need help configuring the eigrp configuration for some reason it just won't work but this is what i have done so far1) subnet appropriately2) Configure EIGRP3) Configure DHCP
Bom dia, Preciso distribuir 3 VoiceVlan em um switch SG350 gostaria de saber se funciona? Porque só identifiquei a opção de colocar VLAN ID em um campo. Já venho utilizando na minha rede com essa opção porém tenho 1 filial que preciso distribuir 3 vo...
Hi everyone,I have a question regarding my ACI environment.I have hinerited a configuration based on several tenants and basically many EPGs each. Now I need the connection of some EPGs from one tenant with some EPGs from another one, this for almost...
Can anyone help me determine what files need to be deleted from flash to completely reset a Catalyst 9300-48U switch to factory defaults?
I'm looking to remove everything that has been added since the time it was pulled out of the box... config, vlan...
Hi All, I have a problem we want to upgrade our switch from SG300 to SG350-28P and im confused with the CLI Old Switch SG 300 Config:interface fastethernet1storm-control broadcast enablestorm-control broadcast level 10storm-control include-multicastp...
Hi I have replaced a router(CPE) with the 3rd party supplier (contractor) I would like to move license from old router to new router - how can I do that ?
We're holding a two-day online conference with six sessions, each a couple hours long with roughly a half hour break in between. The first day runs from 8 - 5, again with breaks. The second runs 8 -4. I only want folks to register once for the entire...
I am getting an alert in Solarwinds as below:
subslot 0/0 transceiver 0 Rx Power Sensor is Critical
In the specified device I checked the status of subslot as below:
INT-RT#sh hw-module subslot 0/0 transceiver 0 status The Transceiver in slot...
My questions are: as WIKI does not seem to have enough definitive info, is there a time-frame for global implementation? Does e.164 and e164.arpa need to operate together, or can e.164 operate without it? I've been looking for a status of e.164, so i...