cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
699
Views
0
Helpful
1
Replies
Highlighted
Beginner

How to find the Interface in which a subslot is connected

I am getting an alert in Solarwinds as below: 

 

Status subslot 0/0 transceiver 0 Rx Power Sensor is Critical

 

In the specified device I checked the status of subslot as below:

 

INT-RT#sh hw-module subslot 0/0 transceiver 0 status
The Transceiver in slot 0 subslot 0 port 0 is enabled.
Module temperature = +19.269 C
Transceiver Tx supply voltage = 3348.5 mVolts
Transceiver Tx bias current = 28586 uAmps
Transceiver Tx power = -4.7 dBm
Transceiver Rx optical power = <-40 dBm

 

Now I am wondering which interface is the subslot 0/0 is connected, I mean which fiber should I investigate to check the problem?

1 REPLY 1
Highlighted
Beginner

sh hw-module subslot 0/0 transceiver 0 status
     The Transceiver in slot 0 subslot 0 port 0 is enabled.
     Module temperature = +28.476 C
     Transceiver Tx supply voltage = 3314.1 mVolts
     Transceiver Tx bias current = 2 uAmps
     Transceiver Tx power = -40.0 dBm
     Transceiver Rx optical power = -40.0 dBm

 

Use this command will show interface 

sh hw-module subslot 0/0 transceiver 0 idprom detail
IDPROM for transceiver TenGigabitEthernet0/0/0:

 

Hope this helps.. 

This widget could not be displayed.