cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
283
Views
0
Helpful
0
Replies
Highlighted
Beginner

Vlan(s) and OSPF

Hi these is my Topology.

I'm able to ping from pc(s) to pc(s), but when I tried to ping for pc 2 to 192.168.101.3 I can't and from Pc4 to 192.168.100.3 

I know my problem is between the switches.

Can someone please help me to understand what am I doing wrong

Thank you!!!

 

Build the following network using the following IP Addressing scheme:

1) Network address 192.168.100.0/24; host addressing requirement: 58 for 2 subnets; VLAN 10 to host IT Group. 

2) Network address 209.165.200.0/24; host addressing requirement is 110 for 2 subnets; VLAN 20 to host Students Group

3) Configure the serial interfaces on routers from the 209.165.200.0/24 address.

Topology:  2 Routers with minimum; 2 serial ports and 2 Ethernet ports;

2 2960 switches; 1 connected to each router.

2 end devices on each switch.

VLAN(s) - are on both sides of the topology;  one configuration of VLAN 10 on the left leg and one configuration of VLAN 10 on the right side of the leg.  Same for VLAN 20.

 


 

VLAN 10 (Left)
pc 192.168.100.2/26
gateway 192.168.100.1
switch vlan 10 192.168.100.3

VLAN 20 (left)
gateway 209.165.200.1/25
pc 209.165.200.2
vlan 20 switch 209.165.200.3

VLAN 10 (Right)
gateway 192.168.101.1/26
pc 192.168.101.2
vlan 10 switch 192.168.101.3

VLAN 20 (right)
gateway 209.165.201.1
pc 209.165.201.2
vlan 20 switch 209.165.201.3


Router 1 - s0/1/0 209.165.202.1 /24
Router 2 - s0/1/0 209.165.202.2
ospf 1
network 209.165.0.0 255.255.0.0 area 0
network 192.168.0.0 255.255.0.0 area 0

Everyone's tags (1)
CreatePlease to create content
This widget could not be displayed.