I would like to do a couple of tests from "BroadWorks Services – Meet-Me Conferencing" chapter of SIP Phone Interoperability Test Plan.
Test plan says "As group administrator, browse to Meet-Me Conferencing → Meet-Me Conference Bridges".
But unable to do this because there is no link Meet-Me Conferencing on the left pane.
Link MeetMe conferencing appeared on the left pane.
But I cannot create new meet-me conf. bridge.
There is no "Meet-Me Conference Bridges".
If I click on Meet-Me Conferencing ports I see only the information about number of allocated ports.
How can I create new meet-me conference bridge?
Yes, I can configure it now but there are only 2 ports available (Maximum Ports Available For This Bridge: 2).
According to interoperability test plan we should test with at least 4 ports.
Could you please also add several ports?
Please disregard my last message.
My group has been expired on weekend and I have created new one with the same name SergeyKhim-Grp1
Could you please do all what you did previously but for my new group and add several ports?
// maximum available ports should be 4
I was not able to check due to problem with calls (https://community.cisco.com/t5/cloud-calling/broadworks-call-is-dropped-after-30-seconds/m-p/4066687)
My group was expired again on Saturday and I have created new one with the same name SergeyKhim-Grp1.
Could you please do all what you did previously but for my new group?
Or maybe there is possibility to do it permanently in order to not asking you to do it each time?