How to run UC-One Desktop Client in call control mode?

[SergeyKhimich19538]

I need to run UC-One Desktop Client in call control mode.

Found some instructions but don't understand how to apply them to Broadworkds sandbox solution.

Which Login URL should I enter to run in call control mode?

As I understood I should enter the Login URL which specially applies for call control mode not usual Login URL.

Or maybe now there is another way to do this?

[skumar1]

As of now, communicator for call control is not supported. 

[SergeyKhimich19538]

OK. Thanks for explaining.

[SergeyKhimich19538]

Is there a plan to support this in the future?

[david.mccann1]

The reply is incorrect - communicator xsi only operation is supported - it requires a separate device profile type from your full UC1 device profile type.  I have attached a writeup that explains it all.  Hope this helps.

[SergeyKhimich19538]

Thanks for information.