cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
720
Views
0
Helpful
3
Replies
csedlmeier
Beginner

ECMP -- 4 times (and more) IPSEC VPN Tunnels to Umbrella SIG Gateway

Dear all.

 

I have a customer that want to connect to Umbrella SIG Gateway with IPsec Tunnels.

Because there will be around 1-2GB Traffice we need to configure 4-8 Tunnels (at moment per tunnel 250MBit later 500MBit)

 

I found following information at Umbrella site for basics Network Tunnel Configuration (umbrella.com)

Here are an example for ISR configuration Manual: Cisco ISR (umbrella.com)

 

In my opinion, if I configure more than one default routes that point to different tunnels. The system should to automatically ECMP between the VPN tunnels.

 

VPN Tunnels to Umbrella SIG are up and running, but I need to check if ECMP is working as expected, and how flows distributed through different tunnels ?

 

Can some tell me what commands I should use to check if ECMP is working ?

 

Thanks in advance.

Christian

1 ACCEPTED SOLUTION

Accepted Solutions
adamwin
Cisco Employee

Hi Christian, I recommend posting this question in the routing board: https://community.cisco.com/t5/routing/bd-p/5991-discussions-wan-routing-switching 

View solution in original post

3 REPLIES 3
adamwin
Cisco Employee

Hi Christian, I recommend posting this question in the routing board: https://community.cisco.com/t5/routing/bd-p/5991-discussions-wan-routing-switching 

View solution in original post

Ok Done. Let's see...

Create
Recognize Your Peers
Content for Community-Ad