06-18-2019 07:27 AM
Hi Experts,
I have deployed umbrella VA 2.4.4 on ESXi and powered on VA. Just after power on VA goes behind DHCP to pick IP and cu environment doesn't have DHCP. Thus i need to assign static IP just after deployment on OVA, however, i don't see way to assign static IP during initial configuration.
Please let me know if there is way to configure static IP just after OVA deployment.
Thanks & Regards,
Jay
06-18-2019 07:34 AM
Jay,
Typically, the VA will only grab an IP address from DHCP if there is one.
However, you can go into the configuration mode and statically set the IP address for your Virtual Appliances.
Here is how:
https://docs.umbrella.com/deployment-umbrella/docs/5-configuring-the-vas
Please rate helpful responses.
Niles
06-18-2019 12:11 PM
06-18-2019 12:11 PM
06-18-2019 12:39 PM
This is the new 2.4.4 that you stated. My apologies.
Try control+B.
Please rate helpful post.
/Niles
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: