C8200-1N-4T + NIM E1 + embedded PVDM4-32 ... no "voice ...." in cli

[Mick35]

Hi,

upgrading voice gateway, from ISR 4k to c8200, I can find all cli commands starting by "voice ...".

Is it normal ?

how to filter codecs as follow with this NIM module :

voice class codec 1
codec preference 1 g711alaw
codec preference 2 g711ulaw
codec preference 3 g729r8

Regards,

[bouchpas]

Did you enable license boot level so that UC is enabled?

______________________
Pascal Boucher
CCNP Collaboration
Spécialiste en Implantations - Communications Unifiées, Lan
IPConsul
T: 514-669-2310 x405
M : 514-970-3690

[cidimage001.png@01D5C4A6.0D9D5E50]
Innovation, Passion et Conseils!

[Nithin Eluvathingal · Accepted solution]

To enable voice commands on the 8200 and 8300 series, you need to activate the DNA licenses using the following command. Once enabled, voice commands will be available:

license boot level network-advantage addon dna-advantage

If you have purchased Network Essentials instead of Network Advantage, replace “network-advantage” and “dna-advantage” with “network-essentials and dna-essentaial ” in the command above.

[Mick35]

Thank you.