cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
2416
Views
5
Helpful
5
Replies
wilsonsant
Frequent Contributor

CIPC 8.6.6 not work with Windows 10

Hi Guys,

 

I am trying to install the CIPC in one machine with windows 10 64bits, but, the CICP not start. The option to configure the TFTP on IP communicator  is not enable. The machine is with mode security disable (firewall). The CUCM is 10.5.2. I reed the release notes about the CIPC and requesed uncheck the parameters about internet explorer, but, the machine have Microsoft Edge.

 

Are there any problem about compatibility between CIPC and Windows 10?

 

Thanks,

 

Regards,

 

Wilson

 

5 REPLIES 5
Roger Kallberg
VIP Advisor

Have you tried to start CIPC as Administrator?
Please rate all useful posts

Hi Roger,

 

Thanks a lot for Your contact. Answering You question, yes, the behavior is the same.

 

Regards,

 

Wilson

Hi Roger,

 

After apply the recommendation did in this link below, worked.

 

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cipc/8_6_6/Release_Notes.html

"


Note


Due to changes to Microsoft Internet Explorer on Microsoft Windows 10, if users set Microsoft Internet Explorer as their default browser on Microsoft Windows 10, user must uncheck Enable Protected Mode in Internet Explorer Security settings. If users do not disable Protected Mode, they will not be able to start the Cisco Unified CM Self-Care portal from the Cisco IP CommunicatorPreferences menu."

 

Thanks,

 

Regards,

 

Wilson

Scott Pedersen
Beginner

I am running 8.6.2.0 on windows 10 without issue. I had to install running as administrator and with windows 7 compatibility I believe. Also need to run the program every time with administrative privileges or it resets tftp and device information and will not allow you to change it.

Hi Pederses1,

 

I only needed use the privilege to do install, after this no.

 

Thanks,

 

Wilson

Content for Community-Ad

Spotlight Awards 2021