cisco jabber CME installation

[ciscodfp]

Hi Experts,

Cisco systems 2911 CME Router, looking a remote android Softphones (Cisco Jabber) for some of the users over VPN .

1. what is the minimum hardware and software requirement for smooth running for Cisco Jabber

2. Regarding the Jabber android License, is it subscription or perpetual. we are looking perpetual solution

3. current firmware or CME version 9.0 is it supportive cisco jabber?

sh telephony-service
CONFIG (Version=9.0)
=====================
Version 9.0

Memory Details:

Cisco CISCO2911/K9 (revision 1.0) with 479232K/45056K bytes of memory.
Processor board ID FCZ1513213G
4 Gigabit Ethernet interfaces
2 terminal lines
8 Voice FXO interfaces
1 Internal Services Module (ISM) with Services Ready Engine (SRE)
Cisco Unity Express 8.6.11 in slot/sub-slot 0/0
DRAM configuration is 64 bits wide with parity enabled.
255K bytes of non-volatile configuration memory.
254464K bytes of ATA System CompactFlash 0 (Read/Write)

Looking your valuable comments

With best Regards

dfpcisco

[Jaime Valencia]

Jabber for Windows was the only Jabber that was ever supported on CME, and it's not supported anymore.

You need CUCM if you wish to use Jabber.

Jabber documentation outlines the requirements for backend servers and clients.

[ciscodfp]

Thanks for the Prompt Respond. appreciate Too
So In CME There is no more alternative ways using IP softphones in android phones over VPN

[Jaime Valencia]

No, the only client we have for Android is Jabber, and it requires CUCM.