Correct, same behavior as if a SW/HW CFB was being used, if the bridge goes down, so does the call and you would need to dial in again, assuming the proper redundancy is configured to choose a working bridge.
If the call happens to be distributed, then those who are in the bridge that fails, goes down, etc. would be the only affected.
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...