Hi,
I am working on CME ver 15.0 to enable AA inside it, and I want when press number 1 will call the extension 1010 and I did this and it works with me when call the 500 internally for test and then I press 1 then call 1010, is good! but the issue when I want to call any extension number internally start with "1" for example " want to cal 1020" then directly forward it to 1010 and I don't want to be like that!
How can I make the hunt pilot only for AA not for internal calls?
:
application
service aa flash:its-CISCO.2.0.1.0.tcl
paramspace english index 1
param number-of-hunt-grps 3
param handoff-string aa
paramspace english language en
param max-time-vm-retry 2
param aa-hunt1 1
param aa-pilot 500
paramspace english location flash:
param second-greeting-time 60
param number-of-hunt-groups 1
param call-retry-timer 15
param welcom-prompt _welcome.au
paramspace english prefix en
param voice-mail 5000
param max-time-call-retry 700
param service-name queue
!
service queue flash:its-CISCO.2.0.1.0.tcl
param queue-len 10
param aa-hunt1 1
param number-of-hunt-grps 1
param queue-manager-debugs 1
dial-peer voice 12 voip
service aa
destination-pattern 500
session target ipv4:192.168.50.1
incoming called-number 500
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
!
ephone-hunt 10 sequential
pilot 1
list 1010
Thanks
