02-13-2020 10:08 AM
I see in the documentation that adding classic to the Jabber config file should set it to Classic mode by default. However I have it in mine and it does not seem to take effect, even after an upload and TFTP reset. Does it go in a specific section? I had it at the end but put in in Options when that didn't work, but neither is taking effect. I have attached the config file.
02-13-2020 10:15 AM
The documentation explains under which section each parameter goes
As you're using a custom name for the config file, you need to configure Jabber to use it, otherwise it will use the jabber-config.xml file it finds in the TFTP.
02-13-2020 10:20 AM
Hi,
You need to specify that parameter under Client section.
<Client> <UXModel>modern</UXModel> </Client>
Please refer to below Jabber Parameters Guide:
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: