cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
374
Views
0
Helpful
2
Replies
Highlighted
Beginner

Jabber Config File - UXMODEL

I see in the documentation that adding classic to the Jabber config file should set it to Classic mode by default. However I have it in mine and it does not seem to take effect, even after an upload and TFTP reset. Does it go in a specific section? I had it at the end but put in in Options when that didn't work, but neither is taking effect. I have attached the config file.

2 REPLIES 2
Highlighted
Hall of Fame Cisco Employee

The documentation explains under which section each parameter goes

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/jabber/12_8/cjab_b_parameter-reference-guide-jabber-128.pdf

 

As you're using a custom name for the config file, you need to configure Jabber to use it, otherwise it will use the jabber-config.xml file it finds in the TFTP.

HTH

java

if this helps, please rate
Highlighted
VIP Engager

Hi,

You need to specify that parameter under Client section.

 <Client>
	<UXModel>modern</UXModel>
 </Client>

Please refer to below Jabber Parameters Guide:

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/jabber/12_7/cjab_b_parameter-reference-guide-jabber-127.pdf

 

 

Please rate helpful posts and if applicable mark "Accept as a Solution".
Thanks, Vaijanath S.