Pause Dialing on Cisco Cube/CUCM

[chaman prakash]

Hi Guys , 

I need help to understand how to achieve the Pause dialing on Cisco Cube .  It is a third party integration with the CUCM 11. 6 .  Speed dial is out of picture.   Here is the scenario

Call Flow--

CUCM-SIP--Cube --SIP--Third party Device

Expectation 

User(third party) will dial 16457PPPP*101#(Here P as Pause). User will dial the number 16457 then the call will connect and wait for 4 pause(4 seconds) pause can vary and then user will enter the *101#( This is a DTMF Digits) . CUCM will capture digits and will route the call to Another Third party Device.

Not sure weather this can be done on CUCM or Cube using the VoIP Dial-peer. Please suggest.

[chaman prakash]

Any one who has deployed or worked on similar environment. 

[Roger Kallberg]

This might get you started with this. https://community.cisco.com/t5/unified-communications/tech-tip-how-to-insert-a-pause-in-the-dialed-number-on-an-h-323/td-p/3584327