cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
312
Views
0
Helpful
4
Replies
Highlighted
Beginner

WebEx DX80: Unable to access Web GUI

Hello All,

We are using Cisco WebEx DX80 with CUCM 12.5.1. We have the CE software on it (ce-9.7.1-30bff6140aa-2019-04-02). I have enabled the web access(both HTTP & HTTPS) on the device setting page as well as on a common device profile. I am still unable to access the Web GUI of the device. It says "the connection refused". 

Please help me with this.

4 REPLIES 4
Highlighted
VIP Engager

Hi,

Are you able to ping the device IP Address from your PC? Is there any firewall or access list that is blocking HTTP/HTTPS traffic ti this device?

 

 

Please rate helpful posts and if applicable mark "Accept as a Solution".
Thanks, Vaijanath S.
Highlighted

Yes. I am able to ping the device from my PC. And I was able to access the web gui before it got registered with CUCM. 

 

Highlighted

Sounds like you have turned off web access in your CUCM. Go to the device properties for the DX80 and look for a section where it disables web access. Click save and apply. It should be back.
Highlighted

Hello Michael,

As I mentioned in the initial post, web access is enabled both on the device settings and common device configuration.