This document was generated from CDN thread
Created by: Cameron Davidson on 02-09-2009 04:06:44 PM
Conecting to Tandberg C60 T1.1 and T2.0 using a AMX NI 3100 there is no comms over IP control unless we use the Tandberg module.
Is this right?
Subject: RE: Amx Tandberg C60 C90 Modual Issues
Replied by: Viggo Fredriksen on 02-09-2009 06:19:49 PM
Hi Cameron,
it is possible to integrate with Codec C60 over IP without using the comm module we're supplying.
To do a pure NetLinx implementation one would have to implement the Telnet protocol. Unfortunately,
we currently do not have a NetLinx implementation example to show.
Regards,
Viggo
