This document was generated from CDN thread
Created by: Andreas Watt on 23-03-2012 05:45:42 PM
I have a C90 codec and a Crestron system. Had full control of unit until 2 weeks ago. Remote works perfectly FYI. Unit is 232 and confirmed that both 232 cable is good and crestron system is sending commands.
Any ideas?
Watt
Subject: RE: Crestron Control
Replied by: null on 11-04-2012 08:12:15 PM
Has this been resolved? We had an issue just like this not too long ago, it was due to a change on how the serial port authenticates when connected to it, as a result of a software update. Have you tried to set the serial port to not authenticate, by turning off the LoginRequired setting?
xConfiguration SerialPort LoginRequired: Off
After we changed this, we had no issues from then forward.