cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

MXP 6000 (F1.0) Not Boot

9
Views
0
Helpful
0
Comments
This document was generated from CDN thread

Created by: Tiziano Vignati on 21-10-2010 12:36:37 PM
The unit will not boot correctly
The console message is :

Break ?
Loading (#2) ... OK
Running F1.0 PAL, 2004-07-05, s50000
Loading video... OK
Loading audio... OK
Break ?
Loading (#2) ... OK
Running F1.0 PAL, 2004-07-05, s50000
Loading video... OK
Loading audio... OK
... again

The codec froze up while changing com port settings on PORT 1  trough web interface.
Turned it off and back on no menus, no video, noting.
Connect with hyper terminal I can get the list of commands back,
at the moment MXP have the eth interface active, but without ip address

How can I fix this bug ?

MXP 6000 (F1.0)
TANDBERG Codec
SoftW: F1.0 PAL
MCU: TANDBERG MXP, featureopt: 1, bandwidthopt: 1107
Date: 2004-07-05
S/N: 25A0xxxx
BootSW: Rev. 1.2, 2004-06-14
MBoard: 100670 rev. 04

Thanks in advance

Subject: RE: MXP 6000 (F1.0) Not Boot
Replied by: David Bruun-Lie on 21-10-2010 04:08:44 PM
Hi Tiziano,
I think you need to contact your local TANDBERG representative or TAC for help on this one

Ciao,
David
CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards