Recall standard layout on MXP

[cdnadmin]

This document was generated from CDN thread

Created by: Jeff Nicoll on 09-04-2010 04:46:39 PM
When using Crestron or AMX, is it possible to recall one of the preset layouts provided (the ones that you toggle through using the remote control layout button) on an MXP without having to toggle through each one?  Can there be a button on the touch panel that immediately invokes a particular one?

Subject: RE: Recall standard layout on MXP
Replied by: David Bruun-Lie on 21-04-2010 03:32:29 PM
Hi Jeff, sorry for the late response

you can use the configuration command to achieve this:

1xConfiguration LocalLayout Mode: <Full/2Split/POP/POPwide>

Best Regards,
David