cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays

Silent Installation of Cisco Unified CM TSP 7.1

435
Views
0
Helpful
0
Comments
This document was generated from CDN thread

Created by: Sriram Santhanam on 07-07-2010 03:58:23 PM
I'm trying to do a silent install on one of our Broker machines using the following.
CiscoTSP.exe /s /v"/qn PASS=\"abc1234\" USER=\"myuser\" CTI1=\"10.1.1.1\"
 
The installation worked fine. No dialog boxes came up.
But after the instalaltion when i went to the Configuration it had the IP Address, User name and password all blank.
 
Is this an issue with the way i specified the parameters or is this a problem with 7.1 that has been fixed with 8.0?
 
Thanks
Ram

Subject: RE: Silent Installation of Cisco Unified CM TSP 7.1
Replied by: Anitha V on 08-07-2010 09:36:38 AM
Hi Ram,
 
Looks like in UCM 7.x, you can perform silent install, upgrade and re-install without parameters.

You can silently install, upgrade, or reinstall Cisco TSP. Use the following commands on the Windows command line:

Installation

CiscoTSP.exe /s /v"/qn"

Upgrade

CiscoTSP.exe /s /v"/qn"

Reinstallation

CiscoTSP.exe /s /v"/qn REINSTALL=\"ALL\" REBOOT=\"ReallySuppress\""
 
so you need to configure the user/pswd and ip address after install from phone and modem option.
 
Please refer to the dev guide of 8.x http://developer.cisco.com/c/document_library/get_file?folderId=192389&name=DLFE-25632.pdf and dev guide of 7.x http://developer.cisco.com/c/document_library/get_file?folderId=192389&name=DLFE-23008.pdf for more details.
 
Thanks and Regards,
Anitha
Cisco Developer Services

 

Subject: RE: Silent Installation of Cisco Unified CM TSP 7.1
Replied by: Sriram Santhanam on 08-07-2010 03:02:16 PM
 
so you need to configure the user/pswd and ip address after install from phone and modem option.
 
Please refer to the dev guide of 8.x http://developer.cisco.com/c/document_library/get_file?folderId=192389&name=DLFE-25632.pdf and dev guide of 7.x http://developer.cisco.com/c/document_library/get_file?folderId=192389&name=DLFE-23008.pdf for more details.

 

Is there a way to automatically set the user/pwd and ip address as part of the install without going into the Phone and modem options. We need to install this in approximately 200 user machines and was wondering the best way to do it. If it does in 8.0 we do not have a problem to switching to 8.0.

Subject: RE: Silent Installation of Cisco Unified CM TSP 7.1
Replied by: Anitha V on 23-07-2010 08:52:09 AM
Hi Ram,
 
Yes it is possible in 8.x.
 
You can automatically set the user/pwd and ip address as part of the install without going into the Phone and modem options.
 
Please refer to the following link: https://developer.cisco.com/c/document_library/get_file?folderId=192389&name=DLFE-25632.pdf
 
Thanks and Regards,
Anitha
Cisco Developer Services
Content for Community-Ad

This widget could not be displayed.