This document was generated from CDN thread
Created by: Stig Karlsen on 02-05-2013 08:54:22 AM
Hi David, or someone.
Just upgrade clients c60 to TC 6.01.
When codec is in DoNotDisturb mode: On and selecting presentaion On, the DoNotDisturb mode is set to Off ??
Clients setup is 2 sources->codec-> 2 monitors, and the whole point here is to prevent incoming calls when DoNotDistrurb mode is activated.
Please advise us.
Thanks,
-Stig
Subject: RE: TC 6.01 DoNotDisturb issue Help !
Replied by: David Bruun-Lie on 10-05-2013 08:19:20 AM
Hm, not able to reproduce here. Are you activating DnD via API/Crestron or Remote Control/Cisco Touch panel?
Also, using xConfiguration Conference 1 DoNotDisturb Mode: On/Off or xConfiguration Conference 1 DoNotDisturb Mode: Timed + xCommand Conference DoNotDisturb Activate/Deactivate?
Cheers,
David