cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays

Trunk selection on CUCM 7.0

22
Views
0
Helpful
0
Comments
This document was generated from CDN thread

Created by: Antonio Rotundo on 28-06-2010 09:00:17 PM
Hi,
I would like to redirect calls to one or more SIP trunks outside of CUCM, by means of a CTI route point.
 
Using a translation pattern I was able to capture all calls (not covered by existing DN), redirecting to RP; however, since pattern transforms called party, in this way I also loose track of originally called number, so I can only redirect call to a new destination on the basis of calling number.
 
Also, I was able to configure a SIP trunk, but I still can't figure out how to select that particular trunk as a selected route.
 
Could you help me?
 
Thank you,
Antonio
 

Subject: RE: Trunk selection on CUCM 7.0
Replied by: Mohan Potluri on 07-08-2010 11:53:23 PM
After creating SIP trunk, you need to create a Route Pattern to configure the SIP trunk in the Route pattern. A typicall configuration of Route pattern would be 9.XXXX. Depending on the dial plan the number of Xs would change. When a user dials 9 followed by DN, call will be routed to SIP trunk.
Content for Community-Ad

This widget could not be displayed.