This document was generated from CDN thread
Created by: Umesh Chaurasia on 15-12-2011 11:38:24 PM
Hi,
Is there any way to trap the event when user IP phone speaker get activated and deactivated? There is no call. We are send RTPMRx command to IP phones and want to trap the stop time when user off the speaker.
Regards,
Umesh
Subject: RE: Cisco IP Phone speaker on/off traping
Replied by: David Staudt on 16-12-2011 04:29:56 PM
Not aware of any way to capture this, the device audio paths and controls are not linked to any phone APIs.