This document was generated from CDN thread
Created by: Marko Laurits on 15-12-2011 03:54:16 PM
Hello,
As I understand, Tandberg PHD 1080 cameras are driven by protocol that is very similar to Sony Visca. ClearOne RAV and Interact mixers are able to control Sony and Canon cameras. So, logically, you can connect Tandberg camera to ClearOne visca port and control the camera by ClearOne. Is that correct?
I have tried to do this but with no success. I have connected Tx, Rx and Gnd pins of the camera and ClearOne visca port. ClearOne shows that the camera is not connected.
Have I done something wrong or doesn't Tandberg camera work behind ClearOne visca port?
Thanks!