cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
25022
Views
14
Helpful
2
Comments
Jeson Chelleth
Beginner
Beginner

=> Steps below are taking an example for PRI. One 1 B channel can be captured at a time.

=> As we do not know which B channel the call will come in on, we need check the right B-channel in real time.

=> For issues relating to call setup, you could try busying out channels, OR using Triggered PCM capture (not discussed here).

=> Same steps can we be used for FXO/FXS ports too, only change the port numbering scheme.

*** PCM capture instructions:

conf t
voice hpi capture destination flash:pcm.dat
voice hpi capture buffer 5000000
exit


>> At this point you need to figure out exactly which voice port  you are on:

show call active voice brief

(http://www.cisco.com/en/US/tech/tk652/tk698/technologies_tech_note09186a008019ab88.shtml)

>> Once you have the port information then you issue the following command:

# test voice port 0/0/0:15.1 pcm-dump caplog 7      ----> assuming you are on PRI 0/0/0:15 and the 1st B-channel

>> Once you are done capturing the issue, do this to stop the capture

# test voice port 0/0/0:15.1 pcm-dump disable
conf t
no voice hpi capture destination flash:pcm.dat
no voice hpi capture buffer 5000000

>> Now do a dir flash: and you will see a file "pcm.dat" that's the file. You will need to send this file to TAC, so it can be analyzed.

>> Remember if you need to redo the call, always delete the pcm.dat file, and start again. Just so that we do not have calls multiple call info in a single PCM file.

Comments
snadimin
Beginner
Beginner

through whihc application can i open pcm.dat file.???????

Amit Sharma
Cisco Employee
Cisco Employee

Please mail to .dat file to TAC for further analysis.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers
Quick Links