Resolution
In order to enable use of a bulk-speed-dial-list, issue the bulk-speed-dial list command in ephone or telephony-service configuration mode. In order to remove the list, use the no form of this command:
- bulk-speed-dial list list-id location This specifies the location of the bulk speed-dial text file in URL format. Valid storage locations are TFTP, Slot 0/1, and flash memory.
- no bulk-speed-dial list list-id This identifies the list to be used. The valid range is 0 to 9.
This is a sample Gateway Configuration:
=============================
telephony-service bulk-speed-dial list 1 bulkdial.txt
bulk-speed-dial prefix #7
Note: The bulk list should not be in .csv format.
After these lines are inserted, reset the phones from the telephony-service mode.
This belongs in the file:
=================
34, 9001403248xxxx, Head Office
Note: These items need to be separated with a comma (,) and a space.
In order to dial the number:
====================
#7134#
This defines the dialed digits:
- #7 This is the prefix. The default is #.
- 1 This is the list number.
- 34 This is the fast dial number for 9001403248xxxx .
For more information Cisco Unified Communications Manager Express System Administrator Guide.