cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
40
Views
0
Helpful
0
Comments
cdnadmin
Advisor
Advisor
This document was generated from CDN thread

Created by: Tiziano Vignati on 21-10-2010 12:36:37 PM
The unit will not boot correctly
The console message is :

Break ?
Loading (#2) ... OK
Running F1.0 PAL, 2004-07-05, s50000
Loading video... OK
Loading audio... OK
Break ?
Loading (#2) ... OK
Running F1.0 PAL, 2004-07-05, s50000
Loading video... OK
Loading audio... OK
... again

The codec froze up while changing com port settings on PORT 1  trough web interface.
Turned it off and back on no menus, no video, noting.
Connect with hyper terminal I can get the list of commands back,
at the moment MXP have the eth interface active, but without ip address

How can I fix this bug ?

MXP 6000 (F1.0)
TANDBERG Codec
SoftW: F1.0 PAL
MCU: TANDBERG MXP, featureopt: 1, bandwidthopt: 1107
Date: 2004-07-05
S/N: 25A0xxxx
BootSW: Rev. 1.2, 2004-06-14
MBoard: 100670 rev. 04

Thanks in advance

Subject: RE: MXP 6000 (F1.0) Not Boot
Replied by: David Bruun-Lie on 21-10-2010 04:08:44 PM
Hi Tiziano,
I think you need to contact your local TANDBERG representative or TAC for help on this one

Ciao,
David
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Quick Links