TS 320 controlled by conductor, TS software version 4.0(2.8)
Endpoints: MX300 and SX20 both TC 7.2.0 code
Conductor and the video endpoints are registered directly to CUCM 10.5 (No VCS)
I have a scheduled meeting in TMS using conductor as the bridge.
I have the meeting set to auto connect and its all working fine, it dials out to the video endpoints and connects properly. (they are set to auto answer)
My concern: If the use accidentally hangs up the call they cant call back by using the recent call list. The incoming call from the bridge is shown as "Callback number sip:10.40.2.10:5060" where 10.40.2.10 is the IP address of the CUCM the TS320 sent the original call via. If the user dialed the full SIP URI of the meeting they can reconnect fine.
Why is the calling address not shown as the full conference URI ?
This could lead to a confusing user experience if they get disconnected
Interesting snippet from the call log on the TS 320 - look at the "From" line in the INVITE.
In this example the conference alias is 55565000 there is some "garbage" before and after the extension and then we see "sip:10.40.1.52" which is the IP of the TS320