After Cisco Unified Video Advantage 2.x is installed on a Microsoft Windows XP PC, the IP phone fail...
After Cisco Unified Video Advantage 2.x is installed on a Microsoft Windows XP PC, the IP phone fails to connect, and the "CCastClient::OnConnect: IP Phone: Connect to Phone failed with Error-Code 00010060" error message appears
After the Cisco Unified Video Advantage (CUVA) 2.0.2 successfully installs on a Microsoft Windows XP PC and the IP phone 7970 is connected to the PC, the camera continually reports that it can not connect to the phone.The output from the Problem Reporting Tool contains this error message:10:49:12 1 CCastClient::OnConnect: IP Phone: Connect to Phone failed with Error-Code 00010060 10:49:12 2 CCastClient::CloseCastConnection: IP Phone: Closing CAST Connection
The 00010060 Transport Control Protocol (TCP) connection error typically means that the connection times out. The Connect to Phone failed with Error-Code 00010060 in the error means that CUVA can not establish a CAST connection to the phone.
In order to resolve this issue, make sure that no AV or firewall blocks TCP port 4224. In order to do this, telnet to the phone with the telnet 4224 port.
In addition, an upgrade of the phone firmware resolves this issue in some cases, if the Cisco CallManager version is 4.x.
This issue is also caused by dual network interface card (NIC) or dual IP address assignment. Make sure that there is only one NIC, and disable all other NICS if applicable, in order to make sure that nothing can prevent the establishment of the CAST connection.
Lastly, if there are two IPs in different subnets on the same NIC on the PC where the camera is installed, remove one IP in order to avoid any IP conflicts.
Dear Folks, I bought a Cisco 8945 phone.The phone is connected to the home broadband network. It is successfully registered with the local VoIP carrier.However it cannot receive incoming calls or make outgoing calls. [CP-8945] 00:00:54:31.078 - ...
Is there a difference in recording calls and mra. We have mra and recording seems to be working for jabber on a laptop vai expressway. The wierd part is that we don't understand why jabber on a mobile with mra via expressway doesn't work but via lap...
When I schedule larger WebEx Events meetings for our system we have a password for attendees and also one for the panelists which is normal or at least seems normal with the invites it creates. When an attendee tries to join from any of our Cisco video en...
Hi We are expanding our outbound dialer from 2x locations to 5 in total for different units. My question is how do we monitor the dialler with regards to congestion due to the units and different dialler compaigns When Would we, in the fut...
Hello, If I am mounting my (2) P60 Cameras to the ceiling, is there a way to invert the display of the video? In other words, because I am mounting my cameras to the ceiling and they will be upside down, is there a setting to ensure the video does no...