In the following cases, the Found New Hardware wizard may appear each time the Cisco Unity server is restarted and report that the voice cards are new hardware, even though the cards are properly installed and configured:
The operating system was installed by using the Platform Configuration discs.
The operating system was installed by using the manufacturer's guided system-setup utility before the voice cards were installed.
New voice cards were added to an existing Cisco Unity server.
Follow this procedure to prevent the Found New Hardware wizard from reporting the voice cards as new hardware. The procedure does not prevent the Found New Hardware wizard from finding and reporting other new hardware.
Note: Cisco recommends disabling virus-scanning services, if applicable, for the duration of the procedure, because running the services slows the Found New Hardware wizard. Re-enable the services when you are finished.
Use the procedure below to disable the Found New Hardware wizard for voice cards:
On the Found New Hardware Wizard Welcome page, click Next. After the Cisco Unity server is restarted, the Found New Hardware Wizard Welcome page is displayed along with the PCI Device Installing dialog.
On the Install Hardware Device Drivers page, click Search for a Suitable Driver for My Device (Recommended), and click Next.
On the Locate Driver Files page, check the Floppy Disk Drives and CD-ROM Drives check boxes, and click Next.
On the Driver Files Search Result page, click Disable the Device, and click Finish. Do not choose to skip driver installation of this device, or the Found New Hardware wizard will continue to appear each time the Cisco Unity server is restarted.
Repeat steps 2 through 4 for each instance of the Found New Hardware wizard (for each voice card, as applicable).
Note that doing this procedure does not prevent a voice card from being displayed as an unknown PCI device when viewed in the Windows 2000 Device Manager. The warning that the device drivers are not installed also continues to be displayed. This is expected behavior, and does not indicate a problem with the card or with the Cisco Unity server.
Hi, we are using CUCM 11.5 with AD integration. If a new employee joins the company, a new User and DN gets created via LDAP sync. All the name fields are correctly imported from the AD to CUCM. The new employee will then use the auto prov...
i have a callback script working for more than a year, i have used the same callback script logic for another application/CSQ but it fails at the point when an agent in the callback queue gets a call and presses a key to connect to the customer. Just...
Hi Experts, We're using cisco ISR 4431 and enabled cdr through syslog. behind 4431 is our genesys call center systems, now we want to consolidate cdr data of genesys and cisco vg cdr. but in vg cdr data, there only connectionid/fcid but no sip call-id whi...
Hi to all I have an SX20 Cisco TelepresenceSoftware version is: TC7.3.15.a9f4c3a I have this issue: WARNING: Default Call ProtocolThe default call protocol is set to H323, but system is not registered on that protocol. The system may n...
Hi, With the recent VCenter security vulnerability (VMware vCenter Server updates address remote code execution vulnerability in the vSphere Client (CVE-2021-21972)), one of the workaround was to disable the CIM server, could any advise the imp...