After the Tool for Auto-registered Phone Support (TAPS) is installed on the Customer Response Solution (CRS) server, all of the calls to the computer telephony integration (CTI) route point fail, and the caller hears dead air. The caller hears no ringback prompts, such as a busy tone or an engage tone.
All of the configuration settings are in place. TAPS is installed without any errors on the logs. The script, the Java Telephony API (JTAPI) trigger, and the application are all present. In addition, the Alternative Automatic Rerouting (AAR) files run properly.
This issue occurs due to a codec mismatch because, by default, TAPS .wav files are codec G711, but CRS uses the G729 codec. There are two ways in order to resolve this issue:
Install TAPS on a different server.
Or, complete these steps in order to convert the TAPS prompts to G729:
Make sure that the prompt names are unique and do not match any in Cisco CallManager and that Cisco CallManager uses G729.
Collect the prompts in the g.711 format. They must be .wav files.
Copy them into a Cisco CallManager that runs the MOH Audio Translator service. Copy the files into the subdirectory of the server:
I have a Cisco 8961 running sip8961.9-4-2SR4-1 firmware. On my config file I have Bluetooth and the USB ports enabled. When I plug in a USB device it says that the port is disabled by the administrator. When I try to find Bluetooth in the setting I c...
I have a Cisco 2911 router with the UC license running IOS c2900-universalk9-mz.SPA.157-3.M.bin abd a SM-ES2-24-P switch installed into it with 5 IP phones connected to the switch. Please note that this is a Service Module switch and not an external switc...
We have registered Webex Team (Windows )with CUCM.My Queries are following:1.Shall CUCM corporate directory work on Webex Teams,just like it works on Cisco Jabber.2.How can we retrieve voicemail on Webex Teams ,just like we do on Cisco Jabber.
Hi, It's nice that Expressway supports certification renewal with ACME / Let's encrypt. Sadly even the current 12.5.5 is still using ACMEv1. This is an old version and is being replaced with ACMEv2 since 2018.I've just had an issue where ACMEv1 didn'...
Hello, I'm running UCM 126.96.36.19900-16 and a subscriber node has stopped to authenticate users. LDAP authentication is configured but even local users fails authentication. There are no authentication attempts in UDS logs with enabled debug leve...