To support analog Foreign Exchange Station (FXS) or Foreign Exchange Office (FXO) voice ports on Cisco 175x Series Access Routers, you need the Voice Interface Card (VIC)-2FXS or VIC-2FXO (either FXS or FXO VIC, or both).
The Digital Signal Processor (DSP) card is called a Packet Voice DSP Module (PVDM), which is installed on the motherboard of the Cisco 175x Series.
The Cisco 1750 platform motherboard has a slot for PVDM modules that provide compression of voice calls so there is no need for an extra Network Module (NM)-2V to house the VIC card.
Make sure your Cisco IOS Software image has the IOS Plus feature set. This is denoted as the "-sv3y" on the image name. If this is not present, the voice hardware is recognized by the platform.
For more information on the FXS or FXO VIC and Cisco IOS Software requirements, refer to these documents:
Note: Calls from the Cisco 175x platform are always run in high complexity mode for the C549 technology type DSP. Therefore, one DSP can handle two calls at most, whereas on other platforms the same DSP can handle either four calls (medium complexity) or two calls (high complexity).
Below are the different combinations of PVDMs for Cisco 1750 and Cisco 1751 platforms.
PVDM-4. Supported on both the Cisco 1750 and Cisco 1751. Contains one DSP and processes two calls (1 FXO/FXS VIC card).
PVDM-8. Supported on both the Cisco 1750 and Cisco 1751. Contains two DSPs and processes four calls (2 FXO/FXS VIC cards).
PVDM-12. Supported on both the Cisco 1750 and Cisco 1751. Contains three DSPs and processes 12 calls (3 FXO/FXS VIC cards).
PVDM-16. Supported only on the Cisco 1751. Contains four DSPs and processes 16 calls (4 FXO/FXS VIC cards).
PVDM-20. Supported only on the Cisco 1751 Digital Signal Processor. Contains five DSPs and processes 20 calls (5 FXO/FXS VIC cards).
Greetings,I am currently studying the CCNP Collaboration (working on CLACCM at the moment) and I was curious as to the viability of MGCP controlled voice ports for PSTN integration over current technologies such as SIP. As it stands I have a deployment th...
Hello, I recently purchased a Cisco 7942G with SCCP firmware and installed SIP Firmware 8.5(4) on it successfully. I also transferred the dial plan and SEP Config files with it. When the phone restarted, I expected it to configure its IP then enter the re...
Hi all, Webex has changed since I last used it. I just hosted a 4 hour meeting and broke the recordings up into 1 / 1.5 hours each. The last one has not appeared in my laptop file. I was prompted to start the meeting in the online browser, but when I hit ...
Hi, I am trying to make the best use of an old EX90 for good instead of dumping it into landfills. I have a free WebEx basic plan and a free Zoom Basic plan. I was wondering how to configure the EX90 for WebEx/Zoom video conference. I was prom...