I am trying to deploy an HA system for a CWMS 2.5 deployment. When I initiate add HA it fails after about 10 -15 minutes.I have noticed that there is a time difference of almost 3 minutes between the Primary and HA hosts. I know from your video that NTP needs to be in synch. My question is, is 3 minutes difference enough to cause a failure for adding HA?
Yes, 3min is a serious time difference that impacts data replication process. Time should be in sync almost to the second (I believe something like up to 12 sec time discrepancy might be tolerated). Make sure that your ESXi hosts use the same NTP server ,that ESXi hosts' times are in sync, and then restart the VMs and try to add HA.
Thanks for your response. After I rectified the time difference on the ESXi node that was out by 3 minutes the HA deployment was successful. Good to get confirmation that this would have been the cause of my problem.
Hi , There's a situation where i am building my custom form element in CVP12.5 call studio. IT is giving fine "initial_audio_group" and "noinput_audio_group" and "nomatch_audio_group" recordings . But the problem is once initial_audio_group is played , an...
view more
If we have a dial-peer has translation rule for outgoing calls, and if the calling number doesn't match with any rule, Will the call pass to the destination or drop?
uccx notification service is down, and unable to start. Due to which Finesse is out of service. could see a bug with similar behavior with no work around. https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvu06189 Please advise to fix this&nb...
view more
I have a sip trunk from Thinktel and have no credentials required. It was configured on 3cx phone system and now I moving it to Cisco ISR 4321 and CUCM. I'm having difficulties trying to make inbound and outbound calls to work, it's always fast busy ...
view more