The following is an example of how to setup call blocking based off of incoming Caller's ANI.
In this example, my voice enviornment consist of an 8.6 CUCM Pub with 3 Subscribers. I have three cisco 2911 h.323 voice gateways with 1 PRI each. I put together this simple 3 step process based off of a Cisco Configuration guide. I tested it on my cell phone and a coupe of others and it worked great. Here are the three steps:
Block Incoming Calls based off of ANI.
The following configuration must be applied to each voice gateway. It is done in basically 3 steps:
1. Create a Translation Rule.
Within the translation rule you will use the reject command followed by the pattern you wish to reject. In this case we use the entire phone number.
I want to pair the Touch 10 with SX80 (already factory reset), but there is no "Pairing" on Administrator Settings of the Touch 10 screen. In this case, would it be better to update both software first? It seems that SX80 could be updated from ...
I have clients that wanted to join meeting in CMS room.
But, when I deployed the CMS, I didn't make a password for the room.
The system said, "The username or password is incorrect".
Is there any problem with the XAMPP, License or what..??
The acronym "STUN" stands for two definitions with two different meanings as follows:
STUN - Simple Traversal of User Datagram Protocol (UDP) ---> RFC 3489 published in 2003 - works only with static NAT to establish a direct connectivity between...
Hello,Can anyone provide some insight on this message that keeps appearing? The configuration isn't changing, but it seems to show up every 10-15 minutes.I've tried the workaround of adding EnableClusterCheck to the .xml file and set it to false, but that...
We are running Unity Connection 11.5 and are looking to pull a report for a large amount of users and the built in report output is pretty atrocious when exporting to CSV. Using CUDLI I think I have the correct tables and mappings, however I need to...